LDAP: couldn't connect to LDAP server

Differences

This shows you the differences between two versions of the page.

--- ee:kicad [2023/10/18 12:46]
24038@students.hsrw [PCB Editor]
+++ ee:kicad [2023/10/18 20:24] (current)
24038@students.hsrw [PCB Editor]
@@ Line 173: / Line 173: @@
 We see everything is okay we can proceed and whenever in doubt recheck the 3D model for a better intuitive oversight.
+While still in the sam grid press Ctrl + Shift  + Z or the icon on the right taskbar "Added filled zone".
+{{:ee:copperzone.png?600|}}
+Select the B.Cu or bottom layer, select the GND net, you can name your zone GND, and leave the other settings the same but change the clearance to 1 mm like so.
+Press B to fill the filled zone and Ctrl + B to unfill. Or alternatively, use the icons on the left taskbar to edit visibility.
+On to top left click "Track" and then Edit pre defined sizes. Add 0.3mm and 0.7mm and press okay.
+{{:ee:boardsetup.png?600|}}
+Now on the right size click the F.Cu for the front copper layer and click (X) to place tracks. Use thicker tracks for power and smaller ones for signals.
+{{:ee:tracks.png?600|}}
+Finally, use the DRC (design rules checker) on the top right and Alt+3 for the 3D model to check if everything is in order.
+DRC:
+{{:ee:drc.png?600|}}
+D:
+{{:ee:3dt.png?600|}}
+Important note:
+Manufacturing capabilities can be found on the manufacturers websites, that includes tracks sizes clearances and so on.
+In the university we can produce only significantly larger track sizes with with 0.8 / 0.7 mm minimum as well as to keep in mind that THT components pads are not connected internally.

User Tools

Site Tools

Differences

Page Tools